Hirose has launched a 1.0 mm coaxial connector that complies with the IEEE Std 287 and supports frequencies up to 110 GHz.

Most printed-board connectors are either a one-piece receptacle or a two-piece plug and jack. With receptacle (edge) connectors, the printed-circuit board foils extend to an edge of the board and are ...

Hirose has launched a 1.0mm coaxial connector that complies with the IEEE Std 287 and supports frequencies up to 110GHz.

Hirose Electric has unveiled a new 1.0 mm coaxial connector designed to support frequencies of up to 110 GHz, offering enhanced flexibility for high-frequency PCB designs.

Amphenol RF has introduced a line of PFAS-free SMA connectors and adapters, expanding its portfolio of high-performance RF interconnect solutions. These products are engineered from PEEK (polyether ...

Amphenol RF announces the introduction of a line of PFAS-free SMA connectors and adapters, expanding our industry-leading ...

You might already be thinking about Asus' BTF solution, which also draws power through fingers on the bottom of the graphics ...

Abstract: Electromagnetic radiation for a commercial printed circuit board (PCB) connector is investigated in this paper. The simulation models of the connector are shown to be validated by comparing ...

MultiLane announced today a major milestone in high-frequency interconnect performance, achieving reliable operation beyond 110 GHz and validating its new PCB footprint architecture up to 120 GHz and ...

Abstract: PCB traces in backplane are typically routed as striplines, which create near end crosstalk, but theoretically, no far end crosstalk. However, in practice, both near end and far end ...